(unknown)

Hi,
I'm trying to run Hello_Fl(latest version) example on a PHYCORE MPC555 with CW8.7, but after making the project when I try to debug,an error occurred(Could not set PC on entry point).
I change the entry point of project in EPPC Linker(__start) to main but it doesn't work too.examine different states of debugger setting so,but each time the error occur ed.
I set my printer port on normal mode and use MSIWiggler(Parallel port) and everything in setting page is default or set by example project.
Some times it goes through and make an powerpc exception error:
'powerpc exception
 machine check exception 0X200'
I think the addresses of the project aren't correct.

{FPU Buffer address   :0x10000000
 Code address           :0x10002000
  Stack Address        :0x100FFFF0   }

Thanks in advance for all your replies.
    
F.Kh