DP256 - DP512 Transition

[Jonathan Masters]

Hello,

Further to my woes from yesterday, I have now discovered that all three
of my pods on three different types of boards using S12DP256, S12DP512
and S12DG128 fail in some way or another.

I have restored the target computer to (much) earlier dates expecting
that perhaps an update had damaged something - no change.

I have uninstalled and re-installed the P&E Drivers and Codewarrior - no
change.

It looks like I have a problem with getting the right .FPP file and the
correct settings in P&E_ICD.INI. What I cannot understand is why I am
working at this level, and how this changed (except that I started
fiddling with the MCU ID for a DP512).

Can anyone give me clues as to the correct settings in the ini file and
the right FPP file.

Can anyone tell me i'm an idiot for trying to do all this with CW12 V3.1
and that all my problems would disappear if I upgraded the software? Can
anyone even tell me that I still have to pay full $$ for a new license
when I already have the software?

Jonathan Masters

[Edward Karpicz]

Jonathan,

Are you using CW debugger? Any chance you enabled Multilink->"At startup CPU
is running (hotplug)" option? This option helps to debug in normal (in not
special) mode of operation, but I believe it should be not compatible with
flash burning. However I could be wrong because I rarely use CW.

Edward



----- Original Message -----
From: "Jonathan Masters" <jon@...>
To: <68HC12@...>
Sent: Tuesday, April 21, 2009 09:29
Subject: [68HC12] DP256 - DP512 Transition

> Hello,
>
> Further to my woes from yesterday, I have now discovered that all three
> of my pods on three different types of boards using S12DP256, S12DP512
> and S12DG128 fail in some way or another.
>
> I have restored the target computer to (much) earlier dates expecting
> that perhaps an update had damaged something - no change.
>
> I have uninstalled and re-installed the P&E Drivers and Codewarrior - no
> change.
>
> It looks like I have a problem with getting the right .FPP file and the
> correct settings in P&E_ICD.INI. What I cannot understand is why I am
> working at this level, and how this changed (except that I started
> fiddling with the MCU ID for a DP512).
>
> Can anyone give me clues as to the correct settings in the ini file and
> the right FPP file.
>
> Can anyone tell me i'm an idiot for trying to do all this with CW12 V3.1
> and that all my problems would disappear if I upgraded the software? Can
> anyone even tell me that I still have to pay full $$ for a new license
> when I already have the software?
>
> Jonathan Masters
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>