Demultiplex MCF5208 data/address

Hi,

I've posted the following question on Freescales Coldfire forum but thought I'd post it here too in case some don't visit Freescale.

I need to regenerate some of the missing address lines on the MCF5208.
I see from the spec that during the first clock cycle the data bus is driven with the address so I assume this can somehow be used to obtain the missing address lines I want.
 
From the timing diagrams the data bus is driven with the address a max of 7ns after the rising edge of FB_CLK, this is the same time as /TS is driven.  This leaves 5ns before FB_CLK goes high again and /TS and the data bus are stopped being driven.
 
I obviously need to somehow use /TS but as it seems to be asserted and negated at the same time as the data bus I don't see how.
 
Can anyone on here help ?
 
Thanks
Paul

________________________________________________________________________
DISCLAIMER:

Information contained in this email or any attachment may be of a
confidential nature which should not be disclosed to, copied or used by
anyone other than the addressee. It may also be legally privileged.
If you receive this email in error, please delete the email from your computer and notify the sender immediately by return E-mail.

Security Warning: Please note that this email has been created in the knowledge that Internet email is not a 100% secure communications medium.  

Virus Warning:
This email has been scanned for all viruses by MessageLabs.
Although this email and any attachment are believed to be
free from viruses, it is the responsibility of the recipient to ensure that
they are virus free. No responsibility is accepted by Bell-Fruit Games Ltd
for any loss or damage arising in any way from their receipt, opening or
use.
---
coldfire@...              Send a post to the list.
coldfire-join@...        Join the list.
coldfire-digest@...    Join the list in digest mode.
coldfire-leave@...     Leave the list.