Hello all,
I got the LCD gum pack a while back and have been happily
playing about with it and picking up bits of info from this list. I
am however at a loss trying to work out how you interface to the
GPIO on the console LCD-vx.
I'm not sure what I want to do but it's a learning experience so
if I could even connect a LED to the system and light it that
would be a start. Ideally I'd like to connect a temperature sensor
but perhaps I should forget the A/D stuff until I can light a led
and maybe "read" a switch state.
This is a seriously basic question. I'm sorry I know this but I've
been searching and can't find any info. Maybe what I expected
is in error. I had expected as the consoleLCD-vx expansion has
GPIO listed in it's features I'd assumed that there'd be solder
points.
If anybody could point me in the correct direction I'd be very
grateful
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace_______________________________________________
gumstix-users mailing list
gumstix-users@...
https://lists.sourceforge.net/lists/listinfo/gumstix-users
