I have my web application using Jigsaw
2.2.0 installed at my client side. It was working fine but once my client
powered off the machine without proper shutdown. Since then it showed a
strange behavior i.e. when a client is connected locally to the application
it works fine but when it is connected from some remote machine it doesn't
work.
When I debugged the issue I realized
that in case of remote client connection, when something is requested from
the session, which was placed in the session in previous call, it is not
found there.
Probably in the first call it assigns
it a particular session and in the next call it doesn't recognize the request
to be of the same session, rather it assigns it a new session.
So I just renamed the previous Jigsaw
install folder and reinstalled the Jigsaw webserver. After that the issue
was solved and everything worked fine. But to my surprize when I restored
the Previous expectedly faulty Jigsaw folder the problem didn't reoccur.
So is there any registry entry or out of install folder file maintained
by jigsaw? if yes then which file could cause such problem? and what steps
I should take to make sure that this problem will not occur again?
Regards.
Ali Raza
