Overo Console

Hi,

Received the new Overo and Summit, and have just had a chance to give it all a go.

Following the instructions at http://www.gumstix.net/Software/view/Software-Overo/Getting-started/111.html (Getting Started), I was pleased to see it all boot and configure a lot of stuff, after which it produced the Angstrom banner and login prompt.

Slightly disappointed to find that it's not accepting any keyboard input, though, so I can't login.

I've checked the console settings, used both kermit and minicom, tried three other USB b-A cables. Same result each time.

Is there an additional step that I need to perform, or is it RMA time?

Many thanks,

James

 James Gill                                                                                                                                        

 Consultant
 Triton Consulting - The Information Management Specialists
 

 Mobile: +44 (0) 7748 766860

 Office: +44 (0) 870 2411 550

 Email: james.gill@...

 Website: www.triton.co.uk

 Registered Office: King Street House, 15 Upper King Street, Norwich, NR3 1RB
 Registered in England, No. 3180592

The contents of this message and any attachments to it are confidential and may be legally privileged.  If you have recieved this message in error you should delete it from your system immediately and advise the sender.

To any recipient of this message within Triton, unless otherwise stated you should consider this message and attachments as "Triton Confidential".