> -----Original Message-----
> From:
geda-user-bounces@... [mailto:geda-user-
>
bounces@...] On Behalf Of Simon_T
> Sent: Tuesday, February 20, 2007 12:56 AM
> To:
geda-user@...
> Subject: gEDA-user: PCB : multiple polygons/planes on ground solder
>
>
> Hello,
>
> I have read the posts on ground planes in this forum.
>
> However i need multiple planes on the same layer.
> 1 ground plane, 1 positive supply plane and 1 negative supply plane.
>
> How can this be done ?
>
> best regards
>
> Simon
>
I use the polygon tool to create the different planes on that layer. I
think on my last board I gave about 50 mils of separation between the
planes. I then hooked up one via to each plane using the therm tool,
thus making that entire plane equal to that net.
_______________________________________________
geda-user mailing list
geda-user@...
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
