On Sat, Jun 21, 2008 at 12:56 PM, Alberto Barradas <
ajcb@...> wrote:
> 1)I boot the installer(11.0) from a harddrive
> partition(hfsplus)
> and the installation system is downloaded from an
> opensuse
Not sure what you mean. When the installation system is downloaded,
it's being loaded into ram. It has a 4 part thing. Once that is
done, the installation starts.
> 2)I have 160MB memory,so is it safe to use X based
> 11.0 installer or would be better to use : install textmode=1
> at the install boot prompt?
If you have less than 256MB RAM, you will need to setup a swap
partition first, or the installer will probably fail. Also, please
list you system specs. Since you say you have 160MB, I assume you are
using a PCI PowerMac(Beige) or a Beige G3?
I also sent this message to the opensuse-ppc list, which is a better
place for you to get answers on PPC hardware related questions. You
can subscribe to it by sending a message to this address:
opensuse-ppc+subscribe@...
---------------------------------------------------------------------
To unsubscribe, e-mail:
opensuse-ppc+unsubscribe@...
For additional commands, e-mail:
opensuse-ppc+help@...
