On Wed, 16 May 2012 20:13:53 +1200, RussellMc wrote:
>Machine 1
>ÿDell Optiplex 760 with Dell E193FP monitor running at max native resolution of
>1280x1024
>ÿIntel 4 Series Internal Chipset, Video BIOS 1676.0
Just looked at the manual for this monitor and blanked with an amber
led gives the maximum power saving that you can get without switching
it off so I'd suggest just go to blanked screen. I'm assuming that the
monitor led goes amber when the screen goes blank.
If the led isn't going amber have a look at the control panel for the
graphics chip and see if there are any options to set no video and no
sync for power off on the monitor. It may be that it's just turning off
video but not v and h sync. Look around in Control Panel both Display
and the screen/display section in device manager. Sometimes you can
adjust what the driver does.
https://support.dell.com/support/edocs/monitors/E193FP/En/specs.htm--
Regards - Rodney Pont
The from address exists but is mostly dumped,
please send any emails to the address below
e-mail rpont (at) gmail (dot) com
--
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist
