On Mon, 21 May 2012 06:46:52 -0700,
"Len Ovens" <len@...> wrote :
> Yes hardware is best. Using envy24control or mudita24, go to the
> patchbay tab and select "Digital Mix L" and "Digital Mix R" as your
> output to 1and 2 outputs. Then on the first tab "Monitor Inputs"
> unmute the track(s) you are using for mic in and set the levels where
> you want. Then goto the next tab "Monitor PCMs" and set the levels of
> the audio coming from the Ardour tracks you already have. That will
> setup your monitor mix. The ardour inputs will see the levels set by
> the analog volume controls
I haven't had much chance to continue with this setup since then.
Today I'm trying to monitor a hardware synth going through a LADSPA
echo effect, set in Ardour. The echo would be used in such a way as an
integral part of the playing, and not jut as a cosmetic add-on. Is it
possible to monitor the output of the Ardour synth track + the LADSPA
delay which is patched after Ardour's volume control for that track (I
also tried patched before it) ? Ardour shows that there is signal
coming in. Sounds go out only in playback mode.
Is it possible to monitor it w/o Ardour actively recording and with
Ardour recording ? I have connected the track's L+R output to playback
3 and 4 using QJackCtl, but the envy24 VUs are not showing any signal.
Hmmmm... I reckon that it might be not so easy to picture the setup.
envy24 patchbay digital mix for both
envy24 monitor inputs 7+8 are hardware synth inputs, signal is shown,
audio is heard.
envy24 monitor PCMs are all very quiet, nothing.
Ardour's track gets capture 7 and 8. LADSPA echo is added pre or
post. Signal is shown in Ardour. No audio heard. After recording, at
playback, audio is heard, shown on envy24 monitor PCM 1 and 2.
How can the signal with the echo added be heard w/o recording ?
Any hints/suggestions would be greatly appreciated !