Hi Harjit,
Is this a platform that's running uClinux like M52277? If it is, you can run
gdbserver/gdb via a serial connection.
Best regards,
Matt
Harjit Singh wrote:
> Has anyone got a serial debugger running on a Coldfire V2 MCF52xxx device?
>
> A while back I read that dBug supports the GDB protocol and dBug is a
> serial debugger. But all posts I have seen, seem to be about using a BDM
> based debugger.
>
> The reason a serial debugger is prefered to a BDM based debugger is that
> I'm doing some robotics work and I can make the servo code run at a
> higher interrupt level than the serial debugger and this will allow me
> to debug code with servos running.
>
> BDM is too intrusive and it will cause the servos to go nuts.
>
> The CF debug docs say that BDM theoretically will steal cycles but
> everything I have read says tha the BDM debuggers halt the CPU...
>
> Thanks in advance.
> Harjit
>
> ------------------------------------------------------------------------
> Windows Live™: Keep your life in sync. See how it works.
> <
http://windowslive.com/howitworks?ocid=TXT_TAGLM_WL_t1_allup_howitworks_022009>
coldfire@...
> Send a post to the list.
coldfire-join@... Join the list.
>
coldfire-digest@... Join the list in digest mode.
>
coldfire-leave@... Leave the list.
---
coldfire@... Send a post to the list.
coldfire-join@... Join the list.
coldfire-digest@... Join the list in digest mode.
coldfire-leave@... Leave the list.
