Re: Display Problem with PelicanHPC v1.8 64bit

Unfortunately this also didn't work. Logged in at the prompt without any problems and ran the pelican_setup script, all grand. When I PXE booted the compute node, it stopped booting at the network card detection. It got as far as:

[ 14.xxxxx ] tg3: eth0: Link is up at 1000Mbps, full duplex
[ 14.xxxxx ] tg3: eth0: Flow control is on for TX and on for RX

at this point it freezes.

I know that using the older PK distribution we had to select the network card driver from the list of drivers during initial cluster set up, the current freezing may be related to that.

If I find a workaround for any of these problems i'll post them up on the forum.

Seán