Re: EF1000is stalling

I did spray carb cleaner around the mounting gasket rpm did not change. On the float adjustment it is plastic and the needle valve has a spring loaded stop pin so I do not think it is adjustable. Disconecting the ccv line to the fuel pump it still runs for a while. One other thing the 12 volt output is 35 volts no load 12 volts with a test light and 7.7 volts with a 5.5 amp load. 110 volt side the light stays steady unless the choke is pushed in then it will roll up and down and stall but takes 20 to 30 seconds before rolling when on econ.
Thanks, Bruce