Re: How to boot Overo Earth on Palo43?

Mine does the same on boot. When you first power it the two lights on the
front side by the power connector come on then go out. look at the mother
board on the other side, it should have a green light on, on it. If it does
not try re seating it and test again. It takes about 30 seconds to a minute
for it to bring up a display on the LCD. Also have you hooked up the consol
port to a computer to see it it is booting on there? If it doesn't maybe
someone else has more info on testing it.

Feng Qian-3 wrote:
>
> Hi,
>
> I just received a Palo43 and LCD. I connected an Overo Air methodboard on
> the Palo board, and connected power to Palo. A red and green light near
> the
> power connector flashed once, then went off. LCD seems powered on, I see
> lights on the side, but no signals. The Overo board has the light on too.
>
> Do I need to something extra to make the board boot?
>
> Cheers,
> Feng
>

> ------------------------------------------------------------------------------
>
> _______________________________________________
> gumstix-users mailing list
> gumstix-users@...
> https://lists.sourceforge.net/lists/listinfo/gumstix-users
>
>

--
View this message in context: http://www.nabble.com/How-to-boot-Overo-Earth-on-Palo43--tp24300835p24301340.html
Sent from the Gumstix mailing list archive at Nabble.com.


------------------------------------------------------------------------------
_______________________________________________
gumstix-users mailing list
gumstix-users@...
https://lists.sourceforge.net/lists/listinfo/gumstix-users