--- In
nslu2-linux@..., "xenshs" <xenshs@...> wrote:
>
> Hello,
>
> a friend of mine gave me his "dead" nslu2 NAS. When I power it on, the "Ready/Status" led first shows up and then start blinking.
>
> I didn't know what to do so I "created" a cheap TTL to RS232 converter and added a serial port (
http://www.nslu2-linux.org/wiki/HowTo/AddASerialPort).
>
> Now I'm able to monitor my NSLU2 from its serial port and here's the output of redboot:
>
> ------------------
> +Ethernet eth0: MAC address 00:c0:02:01:01:02
> IP: 192.168.0.1/255.255.255.0, Gateway: 192.168.0.1
> Default server: 0.0.0.0, DNS server IP: 0.0.0.0
>
> RedBoot(tm) bootstrap and debug environment [ROMRAM]
> Red Hat certified release, version 1.92 - built 15:16:07, Feb 3 2004
>
> Platform: IXDP425 Development Platform (XScale)
> Copyright (C) 2000, 2001, 2002, Red Hat, Inc.
>
> RAM: 0x00000000-0x02000000, 0x000723a0-0x01ff3000 available
> FLASH: 0x50000000 - 0x50800000, 64 blocks of 0x00020000 bytes each.
> == Executing boot script in 2.000 seconds - enter ^C to abort
> RedBoot> boot;exec 0x01d00000
> have eRcOmM
> no node address
> Assign mode
> ------------------
>
> The device is always stucked in assign mode I don't know what to do.
>
> I tried reflashing the firmware with official images without success, I also tried to reinstall it completely from a jtag interface but it's always stucked at this point.
>
> I already read the whole nslu2-linux.org website and tried a lots of things wo success.
>
> Hope to have more answers here :)
>
> Thanks, Romain
>
up :)
