I know that can be difficult to do when you try put Programchange in
the event editor, and try to find where to put the change, so the best
solution to do this is to Cut the segment up.
Eksample:
You have the place you want the pizz to play you cut the segment just
before that happening.
and when that is done, you choose the segment, and go into event
editor, and the first thing you have to set is a programchange to
pizz, and when you want back to sting again, you do the same, just
before you want string you cut the segment.
Was that a good enought explenations? (Excuse my bad english here)
Regards Alf Tonny Bätz
On Sun, Jul 5, 2009 at 11:20 AM, Glyn Adgie<
glyn@...> wrote:
> I thought I would have to do that. I looked at the event editor, but it
> was difficult to see where I was in relation to the score. Perhaps it
> might help if the pizz. and arco parts are in separate segments on the
> same channel. I do not normally make much use of segments. I just extend
> existing segments to add new music.
>
> Glyn
>
>
> ------------------------------------------------------------------------------
> _______________________________________________
> Rosegarden-user mailing list
>
Rosegarden-user@... - use the link below to unsubscribe
>
https://lists.sourceforge.net/lists/listinfo/rosegarden-user>
------------------------------------------------------------------------------
_______________________________________________
Rosegarden-user mailing list
Rosegarden-user@... - use the link below to unsubscribe
https://lists.sourceforge.net/lists/listinfo/rosegarden-user
