Re: Pizz. and arco on same stave

> I know that can be difficult to do when you try put Programchange in
> the event editor, and try to find where to put the change, so the best
> solution to do this is to Cut the segment up.
>
> Eksample:
>
> You have the place you want the pizz to play you cut the segment just
> before that happening.
> and when that is done, you choose the segment, and go into event
> editor, and the first thing you have to set is a programchange to
> pizz, and when you want back to sting again, you do the same, just
> before you want string you cut the segment.
>
> Was that a good enought explenations? (Excuse my bad english here)
>
> Regards Alf Tonny Bätz
>
> On Sun, Jul 5, 2009 at 11:20 AM, Glyn Adgie<glyn@...> wrote:
>> I thought I would have to do that. I looked at the event editor, but it
>> was difficult to see where I was in relation to the score. Perhaps it
>> might help if the pizz. and arco parts are in separate segments on the
>> same channel. I do not normally make much use of segments. I just extend
>> existing segments to add new music.
>>
>> Glyn
>>
>>
>> ------------------------------------------------------------------------------
>> _______________________________________________
>> Rosegarden-user mailing list
>> Rosegarden-user@... - use the link below to unsubscribe
>> https://lists.sourceforge.net/lists/listinfo/rosegarden-user
>>
>