Hi Stuart,
Recently, I've noticed that a full rebuild doesn't go smoothly. In
between some tools keep failing, e.g. efs2prog, etc. So you just need
to do a
bitbake -c clean net-tools
bitbake -c rebuild net-tools
and then continue building
bitbake -c rebuild omap3-console-image
it will pick up from where it last left off. This sort of situation
never used to occur 2-3 months ago, but happens a lot after some
recent updated to overo-oe.
Elvis
On Jul 2, 2009, at 11:49 AM, stuart68 wrote:
>
> Hi,
>
> This worked for u-boot-omap3. I now have this built, but.....
>
> When I try the same for omap3-console-image I get the attached log
> file. It
> is still failing at net-tools. I have started reading through the
> Bitbake
> manual and will try running in interactive mode, but for now please
> have a
> look at my log file to see if there is anything obvious going on.
>
> Thanks,
> Stuart
http://www.nabble.com/file/p24302660/log.do_install.11703> log.do_install.11703
------------------------------------------------------------------------------
_______________________________________________
gumstix-users mailing list
gumstix-users@...
https://lists.sourceforge.net/lists/listinfo/gumstix-users
