Thanks Martin for all your patient replies..
Sorry in case I am being a pain but am back with a fresh set of questions today..
Everyday I play with JOP code in order to get the result I want..Today,I downloaded JOP onto the xilinx kit again(fresh code) and started analysing the code.Before "SCIO BLOCK" there is an extension block where the output is "mem_data" and this data is parallel. So to get the output from SCIO block should I replace SCIO (sc_uart,sc_cnt) with SC2WB.vhd code?I tried this but am stuck when it comes to mapping memory as the last two block's memories are connected.
Am trying to confirm if what I am doing is right. Could you please advise me on how to get the parallel output from SCIO in order to connect it to SC2WB?
The whole idea is to obtain the parallel output from JOP.
Hence connect the output to I2S.
Tan wrote:
Thanks so much for your reply.
We were doubtfull on this issue,so thought of cleraing it..
thanks a ton
cheers
Tan
