Hi Gregg,
There is a version of dBug that should work. I used it when I was
debugging the original 54455 design.
You might check the freescale dbug downloads (I'm not sure where it
is). If you can't find it let me know and I'll ask around (though it is
thanksgiving week).
--Kurt
Granville Gregg wrote:
> Hi all
> Trying to bring up a MCF54450VM240 design currently I am using U-boot-1.2.0. Does anyone have a smaller piece of code that might be easier my design is using a 16 bit data buss with a PC28F256P33B85 I am using the same DDR ram as is used on the reference design MT47H64M8CF-3:F but only two chips instead of 4. Usually when breathing life into one of these I like to use a smaller code base but unfortunately the only thing offered by Freescale is U-Boot under Linux
>
> Thanks Gregg Granville
>
> ---
>
coldfire@... Send a post to the list.
>
coldfire-join@... Join the list.
>
coldfire-digest@... Join the list in digest mode.
>
coldfire-leave@... Leave the list.
>
>
---
coldfire@... Send a post to the list.
coldfire-join@... Join the list.
coldfire-digest@... Join the list in digest mode.
coldfire-leave@... Leave the list.
