Re: fpl and msh

by Carlo de Falco-2 :: Rate this Message:

On 17 Jun 2009, at 22:50, Thomas L. Scofield wrote:

>
> Thanks. I hadn't known that some packages need to be explicitly
> loaded even after they are installed. Once I loaded them, I got
> results from
>
> > demo MSH2Mjigglemesh
>
> I also added gmsh to my path. Now, as I understood the previous
> note, the demo above does not use gmsh. So, if I look over the
> commands in that demo, I will not be seeing examples of what is
> possible using gmsh. Are there examples/demos for full-blown use of
> msh/fpl? Is there documentation available somewhere?

There is a short tutorial in the "doc" directory inside the "bim"
package:
http://octave.svn.sourceforge.net/viewvc/octave/trunk/octave-forge/extra/bim/doc/tutorial.html?revision=5177

Of course the documentation could use some improvement, if you use
these packages for your course and
produce some lecture notes that would be a very valuable contribution...

> Thanks.
> Thomas Scofield

c.

P.S. FPL depends on openDX, be sure to have it installed and in your
path to be able to run the visualization section of the tutorial

------------------------------------------------------------------------------
Crystal Reports - New Free Runtime and 30 Day Trial
Check out the new simplified licensing option that enables unlimited
royalty-free distribution of the report engine for externally facing
server and web deployment.
http://p.sf.net/sfu/businessobjects
_______________________________________________
Octave-dev mailing list
Octave-dev@...
https://lists.sourceforge.net/lists/listinfo/octave-dev

« Return to Thread: fpl and msh