I think I just solved my problem. The signal strength is indeed there.
I just happened to messed up the order inside the radiotap header.
After I adjust the order properly, I can now make kismet shows the
signal strength.
Now I wonder if anyone can tell me what unit is in the raw
signal_strength. Is it in dB? Also, if I also want kismet to show the
noise level, what should I do? Is it possible to deduct it from
signal_quality_ofdm/cck?
Thanks,
Tsuwei
On 8/27/07, Tsuwei Chen <
tsuwei@...> wrote:
> Seems to me that the current driver does not report signal strength in
> the monitor mode. I wonder if anyone is working on that? Tools like
> kismet is currently not able to display signal strength because of
> that. I tried to print out the signal_strength in rx_status but I
> don't think the value is correct when the driver is set to the monitor
> mode.
>
> Is this a known issue? Is there any other way to get the signal strength?
>
> Thanks,
> Tsuwei
>
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/_______________________________________________
Zd1211-devs mailing list -
http://zd1211.wiki.sourceforge.net/Unsubscribe:
https://lists.sourceforge.net/lists/listinfo/zd1211-devs
