TSO logon

[moussa_lebsir]

hi
I configure my tn3270, but I did not have logon screen
what can i do???

[somitcw-2]

--- In H390-MVS@...,
 "moussa_lebsir" <moussa_lebsir@...> wrote:
> hi
> I configure my tn3270, but I did not have logon screen
> what can i do???

   You may have the wrong IP address or port.

   I assume the same PC and IPV4 so IP address
should be: 127.0.0.1
Do not use localhost on new systems because they
may default to IPV6 ::1 unless you update your
HOSTS file.

   I assume the port is: 3270
but it is what you have for CNSLPORT in your
Hercules configuration file.

   After the first screen, old Hercules required
Reset followed by Clear, Attn, or Sysreq to get
to the second screen.  It may need two or three
times of Reset/Clear,  Reset/Attn, or Reset/Sysreq?

   Then assuming you are using Tur(n)key #3, enter:
HERC01

[kerravon86]

--- In H390-MVS@..., "moussa_lebsir" <moussa_lebsir@...> wrote:
>
> I configure my tn3270, but I did not have logon screen
> what can i do???

I'm not sure you've even installed MVS. What have
you downloaded?

I recommend you download this version:

http://mvs380.sourceforge.net

It provides step by step installation instructions,
and if you have trouble with it, I will try to update
the steps after solving your problem. It will at least
get you to the point where you can log on. You can
then replace tn3270 as you wish.

BFN.  Paul.