Hello,
I have a problem with the Emulex LP8000 lpfc driver:
- the kernel module loads fine and reports 4 luns from the storage
(Clariion 4700), also listed in /proc/scsi/scsi, but
- there is no way to have a SCSI device attached (sdb, sdc, ...), even
runing rescan-scsi-bus. The disks are not listed with fdisk -l.
It's the first time I use this setup... Am I missing something?
Thank you for any help.
Alberto
==== Uname -a:
Linux novantatre 2.6.18-rc6 #1 SMP Sat Sep 9 09:46:54 CEST 2006 i686 GNU/Linux
==== lsmod:
Module Size Used by
lpfc 145600 0
scsi_transport_fc 25568 1 lpfc
iscsi_tcp 19808 1
libiscsi 17504 1 iscsi_tcp
scsi_transport_iscsi 23244 3 iscsi_tcp,libiscsi
skge 31312 0
[...]
==== From dmesg:
Emulex LightPulse Fibre Channel SCSI driver 8.1.9
Copyright(c) 2004-2006 Emulex. All rights reserved.
PCI: Enabling device 0000:04:01.0 (0158 -> 015b)
ACPI: PCI Interrupt 0000:04:01.0[A] -> GSI 52 (level, low) -> IRQ 23
scsi6 : on PCI bus 04 device 08 irq 23
lpfc 0000:04:01.0: 0:1303 Link Up Event x1 received Data: x1 x1 x0 x0
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
===== from /proc/scsi/scsi:
Host: scsi6 Channel: 00 Id: 00 Lun: 00
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Host: scsi6 Channel: 00 Id: 01 Lun: 00
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Host: scsi6 Channel: 00 Id: 02 Lun: 00
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
Host: scsi6 Channel: 00 Id: 03 Lun: 00
Vendor: DGC Model: Rev: 0850
Type: Direct-Access ANSI SCSI revision: 04
--
Alberto Cammozzo
System/Network Manager
Universita` di Padova -IT
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to
majordomo@...
More majordomo info at
http://vger.kernel.org/majordomo-info.html